© 2005 directed electronics—all rights reserved
5
NNOOTTEE::
If you can close the vehicle’s windows by turning the key in the door,
SmartWindows 4 will not operate properly. Refer to the “Window Control” section of
this manual.
install the smartwindows 4 accessory
NNOOTTEE::
Refer to the Wiring Quick Reference Diagram at the back of this manual for
the following instructions.
1. Connect one end of the CliffNet Dataport Interconnect cable to the alarm
system control unit and connect the other end into the SmartWindows 4
module.
2. Connect the 14AWG BLACK wire to the chassis ground.
3. Connect the 14AWG RED wire from the pigtail to a 30 amp fuse at the battery
positive cable clamp, connect the 18AWG RED wire to a 5 amp fuse at the
battery positive cable clamp. Connect 18AWG BLACK wire to the battery
negative battery cable clamp.
NNOOTTEE::
For one touch operation on the passenger switch, connect between the pas-
senger switch and the window motor. For normal passenger switch operation, con-
nect anywhere between the driver and passenger switches.
motor/switch connections
NNOOTTEE::
Refer to the Wiring Quick Reference Diagram at the back of this manual for
the following instructions.
1. Turn the ignition switch to the “ON” position.
2. Access the wires at the window motor.
3. Connect the negative voltmeter lead to ground.
4. Connect the other voltmeter lead to a wire at the driver’s side window motor and
find the wire that shows 12V while pressing the driver’s window switch as if
rolling the window up.
a. If the voltmeter reads 12 volts while pressing the “UP” side of the switch,
cut this wire. (If you do not get a 12V reading while rolling the windows
up, then connect (-) lead of the voltmeter to +12V and probe the window
wires. If you find a wire that shows +12V while rolling the window
up/down, go to the Motor/Switch Connections - Negative Switches section
below.)
Comentarios a estos manuales